Pages

Friday, September 11, 2009

Stereo, Parallel, and Bridge Mono Modes in Amplifiers

One of the most frequent questions we get is the difference between stereo, parallel, and bridge mono modes in Amplifiers

Stereo Operation

Stereo operation mode is the normal, default mode of an amp. This means that the amplifier provides power to two independent channels. Think of it as two amps in one. Many recent amps can even run two different power/resistance ratings on the two channels at the same time. Usually we run two outputs (left and right) from a mixer, into the two amp channels (left and right), and then into two speakers set up in front of an audience, one on the left, one on the right. This enables an audience to enjoy the stereo effects of music.

Parallel Operation

Parallel operation routes an identical audio signal of one amp input into both channels. You use this to route a mono input (like a microphone, or mono output of a mixer) into both channels of an amp. It is the same as using a Y cable to split a mono input into both channels. After the input, the amp acts exactly like a stereo mode amp.

Bridge Mono Operation

Bridge mono mode combines two amp channels into one mono, much more powerful amp channel. This is most often used for subwoofers. Amplifiers have separate stereo and bridged mono power handling specifications. For instance, the Alto MACRO 1400 amp is rated at 310 W at 8 ohms STEREO, and 900 W at 8 ohms BRIDGE MONO. The advantage of bridge mono is that you have a much higher power rating; the disadvantage is that you have only one amp channel.

Connecting speakers to an amp in bridge mono mode is different from stereo mode. Usually you connect a banana plug to the middle two banana outputs. You must also flip the amp into bridge mono mode, using dip switches on the back of your amp. Consult your amp manual for specific directions on your particular model.

10 comments:

  1. wondeful!!!this whole information is absolutely useful and interesting. i like this blog because is easily understandable, and that is invaluable to the readers. I wanted to buy viagra online, and i saw this blog. I think this information will be useful for me specially because I want to get a great stereo and take advantage about it.

    ReplyDelete
  2. PA amplifier is an electronic device that used to increase the sound, voltage, current, and power of signals. We have a great collection of PA amplifiers. If you want to buy you can visit our site. Best PA amplifiers WA

    ReplyDelete
  3. The best thing about your sharing and posting is that you always provide content that is helpful.
    Home Automation in Bangalore | Video Automation Company Bangalore | AV Receiver in Bangalore

    ReplyDelete
  4. So a squire 4 channel mixer with 2 parallel outputs is "mono" ?
    https://i.imgur.com/PtpCbPS.jpg
    https://i.imgur.com/3p4pT20.jpg
    https://i.imgur.com/IIru2UC.jpg

    ReplyDelete
  5. Very useful information, thank you so much..

    ReplyDelete
  6. Can I use different ohms each side at the same time on studiomaster 3.0 Please.

    ReplyDelete
  7. On NRS AM3003 Power Amp to connect with 1000W 15” InkeL single Tops which mode is suitable Stereo or Bridge please advise
    Gain set on to “0” is it correct?

    ReplyDelete